Qwiic Management at Your Fingertips – Information

Swap it up, and take away these batteries with ease! Take a look at our new merchandise this week.

Howdy once more everybody and welcome again to a different Friday Product Put up right here at SparkFun Electronics! This week, we’ve two model new merchandise to shut out January! We’re happy to announce the model new SparkFun Qwiic Navigation Swap, a brand new technique to management your Qwiic gadgets together with sensors, shows, robots and extra. After that, we’ve a software that every one of our engineering professors insisted that we use, a customized JST Battery Elimination Device! Let’s leap in and take a better have a look at each of those new merchandise!

SparkFun Qwiic Navigation Swap

PRT-27576

Add a 5-way joystick and RGB LED to your venture with the Qwiic Navigation Swap! I2C communication and Qwiic join make i…

The SparkFun Qwiic Navigation Swap provides a small, joystick-like 5-way tactile swap to your I²C bus! When linked to a microcontroller, push the 5-way tactile swap towards a course (up, down, left, proper, or middle) to offer further enter in your software. The built-in RGB standing LED gives visible suggestions indicating when a swap is pushed.

Populated on the board is a 5-way tactile swap. Every course features a momentary swap that’s learn by the PCA9554 8-bit I2C I/O expander and notifies the microcontroller when a swap is pushed. The microcontroller will then present visible suggestions by writing to the non-addressable RGB LED. Every channel of the RGB LED will be disconnected from the PCA9554’s GPIO and linked to a special enter. An interrupt pin can be damaged out to inform your microcontroller when a state has modified rapidly. We have additionally included an LED for energy. Using our helpful Qwiic system, no soldering is required to attach it to the remainder of your system. Nonetheless, we nonetheless have damaged out 0.1in.-spaced pins should you desire a breadboard.

SparkFun JST Battery Elimination Device

TOL-27923

The SparkFun JST battery elimination software is a software to take away an ordinary 2-pin JST-PH connector (2mm pitch) from its housing! Eas…

The SparkFun JST Battery Elimination Device is a software to take away an ordinary 2-pin JST-PH connector (2mm pitch) from its housing! Simply take away a LiPo battery’s 2-pin JST-PH feminine connector utilizing the JST battery elimination software! Save your fingertips from grabbing the connector when wiggling the connector out. Keep away from by accident pinching the wires when utilizing needle nostril pliers. Or save your wires from being minimize when utilizing a diagonal cutter. Merely slide the software over the LiPo battery’s JST feminine connector with one hand. Together with your different hand holding the male connector, pull the JST feminine connector away to disconnect the battery!

That is it for this week. As at all times, we will not wait to see what you make! Shoot us a tweet @sparkfun, or tell us on Instagram, Fb or LinkedIn. Please be secure on the market, be sort to at least one one other! Completely happy hacking!

By no means miss a brand new product!